Building solidMechanics in OpenFOAM 1.6-ext on Mac OS X
Hi Philip -
Basically, I have OpenFOAM-1.6-ext complied on the computer. Following the thread thus far, to the best of my ability, I did the following: Code:
git clone git://git.code.sf.net/p/openfoam-extend/OpenFOAM-1.6-ext nextRelease-1.6-ext Code:
make: *** [Make/darwinIntel64GccDPOpt/elasticPlasticSolidFoam.o] Error 1 Thank you, Eric |
What I have tried so far is:
Code:
git clone git://git.code.sf.net/p/openfoam-extend/OpenFOAM-1.6-ext ~/OpenFOAM/newRelease Code:
hcp-128-83-76-122:solidMechanics eric$ ./Allwmake |
Greetings Eric,
I've moved your two posts from the thread http://www.cfd-online.com/Forums/ope...am-extend.html because this seems to be more of an installation problem of OpenFOAM 1.6-ext on Mac OS X. The problem you are having with this: Quote:
One simple test that you can make is to run this command: Code:
export | grep FOAM
Best regards, Bruno |
solved issue
Hi Bruno -
Thanks for pointing out one source of the problems I was seeing. At some point, however, I gave up attempting to install the solidMechanics source into the 1.6 extend stable, and instead compiled the newRelease branch entire. The later ultimately proved successful, following the advice of a co-worker and: http://openfoamwiki.net/index.php/In...1.6-ext/Ubuntu ... running Ubuntu 12.04 on VMWare Fusion. |
updated solution
Edit:
Presently I install solidMechanics solvers via foam-extend-3.0, per my thread, and with other wiki installation instructions also available. |
All times are GMT -4. The time now is 07:57. |