|
[Sponsors] |
[solids4Foam] How to setup dynamicMeshDict for flexible body with rotating oscillation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 14, 2023, 14:04 |
How to setup dynamicMeshDict for flexible body with rotating oscillation
|
#1 |
Member
GS
Join Date: Mar 2016
Posts: 81
Rep Power: 10 |
Hello everyone,
I've successfully run the Turek Flag simulation in foam-extend 4.1 using solids4Foam. However, I'm encountering challenges when trying to modify the dynamicMeshDict due to my limited understanding of the varying keywords. My goal is to simulate the Turek Flag with both oscillation and rotation. The different motion-solvers and associated coefficients have been somewhat elusive for me. Could someone provide guidance or share an example on how to set up the dynamicMeshDict for a flexible body that exhibits rotating oscillation? Any assistance would be greatly appreciated. Thank you! |
|
Tags |
fsi dynamicmeshdict |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
I can't make my body rotating in transient structural | sheaker | ANSYS | 2 | December 7, 2019 19:13 |
DLR - F6 wing body Meshing+Fluent setup + solution | Far | FLUENT | 0 | May 16, 2012 15:52 |
Rigid Body Motion Setup for Tesla Turbine | me3840 | FLUENT | 0 | October 26, 2011 18:54 |
Best choice for my setup ? Sliding mesh or single rotating ref frame ? | Rockda | FLUENT | 0 | August 23, 2011 06:05 |
Please help Single rotating frame Setup | jaswi | OpenFOAM Running, Solving & CFD | 0 | June 8, 2007 09:24 |