workflowControls options result in that Paraview cannot open
After using any of the workflowControls options I'm left with files that
Paraview cannot open. What is required to make these readable? cfMesh ver 1.1.1, of 2.4 |
Quote:
workflowControls stops the meshing process at some intermediate stage in the meshing workflow, writes the current status of the mesh on disk and exits. It seems the mesh was not saved correctly in this case. Do you maybe use binary/uncompressed? This combination sometimes causes problems. My recommendation is to use binary/compressed. I have never had any problems with it. |
Found MY error.......problem solved.
|
All times are GMT -4. The time now is 19:47. |