CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Community Contributions

[cfMesh] Inspect result mesh

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   October 26, 2019, 12:01
Default Inspect result mesh
  #1
New Member
 
Patrizio
Join Date: Mar 2013
Posts: 7
Rep Power: 8
Dry Patrick is on a distinguished road
I'm trying to visualize the mesh from the tutorial "cutCubeOctree" in Paraview.
After running the tetMesh command in cfMesh console, looking into the "constant\polyMesh" folder, I can found the output file into .gz archives which contain ASCII mesh.



How can i convert these files to inspect them in Paraview or in any other GUI?



Thanks for the suggestions!!
Dry Patrick is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
how to set periodic boundary conditions Ganesh FLUENT 14 November 26, 2018 12:26
Too diffusive result on Delaunay type mesh for pipe AlmostSurelyRob OpenFOAM Running, Solving & CFD 7 October 8, 2018 14:34
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) shubham jain ANSYS Meshing & Geometry 1 April 10, 2017 06:03
[snappyHexMesh] Snappyhex mesh: poor inlet mesh Swagga5aur OpenFOAM Meshing & Mesh Conversion 1 December 3, 2016 17:59
sliding mesh problem in CFX Saima CFX 45 September 22, 2015 11:53


All times are GMT -4. The time now is 18:28.