[cfMesh] Inspect result mesh -- CFD Online Discussion Forums

October 26, 2019, 11:01	Inspect result mesh	#1
Dry Patrick New Member Patrizio Join Date: Mar 2013 Posts: 7 Rep Power: 13	I'm trying to visualize the mesh from the tutorial "cutCubeOctree" in Paraview. After running the tetMesh command in cfMesh console, looking into the "constant\polyMesh" folder, I can found the output file into .gz archives which contain ASCII mesh. How can i convert these files to inspect them in Paraview or in any other GUI? Thanks for the suggestions!!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
Too diffusive result on Delaunay type mesh for pipe	AlmostSurelyRob	OpenFOAM Running, Solving & CFD	7	October 8, 2018 13:34
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters)	shubham jain	ANSYS Meshing & Geometry	1	April 10, 2017 05:03
[snappyHexMesh] Snappyhex mesh: poor inlet mesh	Swagga5aur	OpenFOAM Meshing & Mesh Conversion	1	December 3, 2016 16:59

All times are GMT -4. The time now is 05:14.