 |
 |
 |
|
|
|
[Sponsors] | ||||
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 29, 2014, 18:00
|
|
#301 |
|
Senior Member
Fatema Zandi Goharrizi
Join Date: Mar 2009
Posts: 158
Rep Power: 16  |
Hi
I found the answer.  we have first select the OF version, as I have 3 different version(of220, of230 and ofe30). so if we do have just one it does not get that error. after that, I got error:  No 'bison' found. This is absolutely essential for swak4Foam. Can't go on I followed these commands  (A) Install flex from terminal: sudo apt-get install flex (B) Install bison from terminal: sudo apt-get install bison (C) If you dont have gcc installed, you can get it using sudo apt-get install gcc it does get ok  but again there is a problem !!! I'm going to start from first!! yes I did it. just select the OF version then do A, B anc C steps to install bison, then install swak4Foam from the wiki guidance. 
Last edited by zandi; November 1, 2014 at 06:59. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ship resistance shows wiggles when using Overset mesh and dynamic mesh in Fluent | Qingsong | FLUENT | 2 | March 21, 2022 15:08 |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| [ICEM] Dynamic mesh setup with ICEM | David121284 | ANSYS Meshing & Geometry | 0 | April 11, 2014 04:19 |
| Dynamic Mesh "Shadow Wall" | thezack | FLUENT | 0 | June 4, 2013 22:09 |
| dynamic mesh for drop interface | IndrajitW | FLUENT | 0 | March 30, 2013 08:03 |
6Likes
Linear Mode
