 |
 |
 |
|
|
|
[Sponsors] | ||||
March 10, 2014, 10:42
|
Problem with Paraview
|
#1 |
|
New Member
Join Date: Mar 2014
Posts: 2
Rep Power: 0  |
I have follow this tutoriels to install OpenFoam and Paraview: http://www.openfoam.org/download/ubuntu.php
When I compile the simplest figure cavity, the surface of my figure isn't smooth. There is like hole and when I move my figure the hole change. There is a picture in the attachment. Thanks for your help ! A.Danthine |
|
|
|
|
|
March 10, 2014, 15:12
|
|
#2 |
|
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,974
Blog Entries: 45
Rep Power: 128  |
Greetings Danthine and welcome to the forum!
That's a clear indication that the graphics card drivers are not fully compatible with your graphics card. You need to either install the correct drivers or upgrade your existing ones. Note: on some occasions, instead of upgrading the drivers, you might need to downgrade them. Best regards, Bruno
__________________
|
|
|
|
|
|
|
March 10, 2014, 15:23
|
|
#3 |
|
New Member
Join Date: Mar 2014
Posts: 2
Rep Power: 0 |
Thanks a lot ! I will check that
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [General] Problem in using paraview | meballav | ParaView | 11 | October 12, 2012 16:03 |
| [OpenFOAM] Installation problem with ParaView 3.8.0 on openSUSE 11.2 | aero_ | ParaView | 14 | August 2, 2010 18:13 |
| Yet another Paraview problem | gascortado | OpenFOAM | 5 | February 21, 2010 06:39 |
| paraFoam reader for OpenFOAM 1.6 | smart | OpenFOAM Installation | 13 | November 16, 2009 21:41 |
| [OpenFOAM] Problem with Colors in ParaView | sven | ParaView | 1 | May 31, 2009 08:13 |
Linear Mode
