Problem with Paraview
1 Attachment(s)
I have follow this tutoriels to install OpenFoam and Paraview: http://www.openfoam.org/download/ubuntu.php
When I compile the simplest figure cavity, the surface of my figure isn't smooth. There is like hole and when I move my figure the hole change. There is a picture in the attachment. Thanks for your help ! A.Danthine |
Greetings Danthine and welcome to the forum!
That's a clear indication that the graphics card drivers are not fully compatible with your graphics card. You need to either install the correct drivers or upgrade your existing ones. Note: on some occasions, instead of upgrading the drivers, you might need to downgrade them. Best regards, Bruno |
Thanks a lot ! I will check that
|
All times are GMT -4. The time now is 23:42. |