Error: Windows Installation
1 Attachment(s)
Hi All,
I am trying to install openfoam on Win 7 using the installer provided. I followed all instructions but I am getting some error messages. A screen shot is attached. Please help me installing this software. Note: I manually started boot2Docker. Thanks. |
There is issue with installation .. Any reason why it is being run as administrator. i.e your snapshot show it is being run as administrator.
Also i assume virtualization is enable in your system , if not please enable it and then reboot system twice and reinstall everything after un-installing all component plus other instruction as given in readme file |
I used havdetectiontool, does it enable hardware visualization? If not, how can I do this?
Don't worry, I checked that hardware visualization is enabled. I will reinstall tomorrow and post the result. |
From http://openfoam.com/download/txt/ope...adme_v3.0+.txt
First check whether it is enable or not 1) Hardware assisted virtualization should be enabled. If not already done, please enable it from the BIOS mode(see below), then reboot your system twice before proceeding with this Installation. In Windows7, check if hardware-assisted Virtualization is switched on by running the Windows utility https://www.microsoft.com/en-us/down...d=592#filelist 2. Search internet how to enable hardware virtualization in windows 7. Ideally, you need to go to go BIOS settings and enable virtualization . https://access.redhat.com/documentat...s_in_BIOS.html |
Quote:
|
Problem in running OpenFoam
1 Attachment(s)
I installed too, but I couldnīt run it.
Te attached error appeared when I openned the program. |
Quote:
Quote:
|
Hi,
I would suggest to use the following link to install OpenFoam under windows: http://www.cfdsupport.com/download-o...r-windows.html Best regards, mqsim |
All times are GMT -4. The time now is 08:11. |