 |
 |
 |
|
|
|
[Sponsors] | ||||
[OpenFOAM.org] splitMeshRegions:command not found |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 6, 2020, 13:43
|
splitMeshRegions:command not found
|
#1 |
|
New Member
Join Date: Aug 2020
Posts: 7
Rep Power: 5  |
Hello,
I think I have a problem with my installation of OpenFOAM. I ran the tutorial snappyMultiRegionHeater in my OpenFOAM-3.0.1. It was okay when I used the blockMesh and snappyHexMesh. But when I try splitMeshRegions -cellZones -overwrite I have the following error message, "splitMeshRegions: command not found". Please tell me some ideas to solve the error. Thanks! |
|
|
|
|
|
April 14, 2024, 09:38
|
|
#2 |
|
New Member
Join Date: Dec 2022
Posts: 3
Rep Power: 3 |
You simply misspelled it, instead use:
splitMeshRegion -cellZones |
|
|
|
|
|
|
| Tags |
| splitmeshregions |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [RapidCFD] Discussion thread on how to install and use RapidCFD | newoscar | OpenFOAM Community Contributions | 84 | September 2, 2022 01:04 |
| Gmsh installation on terminal help | spitfire | Main CFD Forum | 4 | July 27, 2017 15:11 |
| [Other] Mesh Importing Problem | cuteapathy | ANSYS Meshing & Geometry | 2 | June 24, 2017 05:29 |
| Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |
| Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
Linear Mode
