 |
 |
 |
|
|
|
[Sponsors] | ||||
[foam-extend.org] Issues Running foam-extend Utilities on WSL |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 18, 2021, 18:33
|
Issues Running foam-extend Utilities on WSL
|
#1 |
|
New Member
Sayre Satterwhite
Join Date: Jan 2021
Posts: 4
Rep Power: 5  |
Hello,
I am attempting to make the switch to foam-extend 4.1 from Openfoam8. I am using WSL with Ubuntu 18.04. I believed that I had installed everything correctly after much trial (everything in the foam-extend folder seems to be present, including all the utilities), however, when I go to run a utility on a case, such as blockMesh, it says "command not found". I tried both the tutorials with foam-extend and some of the cases I've been working on in OpenFOAM8, however, I get the same result. Do I have everything installed correctly, or am I going about foam-extend in the wrong mindset coming from OpenFOAM8?  Thank you |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [CGNS] CGNS converters available | mbeaudoin | OpenFOAM Meshing & Mesh Conversion | 137 | December 14, 2018 04:20 |
| [mesh manipulation] RefineMesh Error and Foam warning | jiahui_93 | OpenFOAM Meshing & Mesh Conversion | 4 | March 3, 2018 11:32 |
| is internalField(U) equivalent to zeroGradient? | immortality | OpenFOAM Running, Solving & CFD | 7 | March 29, 2013 01:27 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
| Problem with rhoSimpleFoam | matteo_gautero | OpenFOAM Running, Solving & CFD | 0 | February 28, 2008 06:51 |
Linear Mode
