|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
|
starting paraview takes me 10 minutes, I think there is something wrong.
do u think i should install VTK? Following is copied from paraview's help->about paraview 1.8 ParaView was developed by Kitware Inc. http://www.paraview.org http://www.kitware.com This is version 1.8, release 5 Runtime information: Software Rendering: Disabled Satellite Software Rendering: Disabled Stereo Rendering: Disabled Offscreen Rendering: Disabled Tiled Display: Disabled Using RenderingGroup: Disabled Render Module Used: LODRenderModule Network Configuration: (none) Cave Configuration: (none) Compositing: Enabled BatchScriptName: (none) PlayDemoFlag: 0 DisableRegistry: 0 CrashOnErrors: 0 Port: 11111 StartEmpty: 0 Username: (none) HostName: localhost ParaViewScriptName: paraFoam.pvs ParaViewDataName: (none) Tcl/Tk - Copyright (c) 1989-1994 The Regents of the University of California. - Copyright (c) 1994 The Australian National University. - Copyright (c) 1994-1998 Sun Microsystems, Inc. - Copyright (c) 1998-2000 Ajuba Solutions.
__________________
rdu ------------------ Martin/Run Du |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
V4 very slow! | Steve | Siemens | 3 | June 9, 2006 07:37 |
Converging very slow | Q | FLUENT | 0 | March 16, 2006 03:48 |
[OpenFOAM] HI all I cant find display button in paraview when i execute cavity tutorial there is only parameter button in the paraview | chan | ParaView | 2 | February 13, 2006 07:37 |
DPM slow evaporation | Vix | FLUENT | 3 | November 30, 2005 13:38 |
very slow flow | Francisco | Fidelity CFD | 3 | November 10, 2004 04:35 |