CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Installation (
-   -   gmsh2ToFoam (

s&m April 27, 2009 07:01

Hi to everyone,
First of all, congratulation for you site, it's great! Unfortunately i have a problem with OpenFOAM 1.5.
I've installed it on ubuntu 9.04, it works fine (the file cavity works), but now that i want to install gmsh2ToFoam, i don't know what i have to do because i started to use linux only some weeks ago.
I tryed to look in other post but there was not an explicit answer, they say, go to wiki download the file, and then compile again OpenFoam.

I woul like to explain what i understood:
1- download gmsh2ToFoam-20070312.tar.gz
2-i put in directory /openfoam/application/utility/mesh/conversion/
3- unzip
4-recompile with: "wmake all"
it's right?
If i wrong can you write the right steps for OpenFoam 1.5?


7islands April 27, 2009 21:00

Hi s&m,

1. svn co https://of-interfaces.svn.sourceforg...trunk/gmshFoam
2. cd gmshFoam
3. ./Allwmake


All times are GMT -4. The time now is 15:07.