 |
 |
 |
|
|
|
[Sponsors] | ||||
June 28, 2012, 14:47
|
Dynamic Mesh Motion
|
#1 |
|
New Member
jake
Join Date: Jun 2012
Posts: 1
Rep Power: 0  |
I am an OpenFOAM beginner, so I apologize in advance for any ineptitude.
I am attempting to mesh an object which, upon being pushed by the fluid, moves. It is VERY much like the wingMotion tutorial. However, after a bit of time running, it crashes - the mesh, at this point, has stretched greatly. Is there any way I can prevent the mesh stretching? I know the mesh can move with the object (movingCone) but what if the motion isn't prescribed? I believe the mesh stretching is the issue since if I modify the wingMotion tutorial to move a lot more (thus stretching a lot more) I get an identical crash. Any ideas? Thank you for your time. |
|
|
|
|
 |
| Tags |
| motion dynamicmesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| dynamic mesh for the impeller with rotational and downward motion | socreate | Main CFD Forum | 0 | July 11, 2016 04:59 |
| Dynamic mesh - exclude mesh motion in bc | Tscar | OpenFOAM Running, Solving & CFD | 0 | May 10, 2016 05:14 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| Update of the variables after dynamic mesh motion. | gtg258f | OpenFOAM Programming & Development | 9 | January 18, 2014 10:08 |
| Turbulent problems during Dynamic Mesh Motion | arturojortega | FLUENT | 2 | June 2, 2009 10:33 |
Linear Mode
