[Other] makeStructuredGridMesh.py file

rohit3051 · April 2, 2013, 18:20

I have found an open source for simulating air flow in an air condition room, but I cannot understand how the mesh is created here. I could find makeStructuredGridMesh.py file in there, but was not able to decipher what it is doing exactly. Can anyone help me understand how does this code work.

Also I have a blockMeshDict file for my model for which I need to make changes so that it functions like the example problem. How can I collaborate these two.

Any help is greatly appreciated.

JR22 · April 2, 2013, 19:09

Did you get that file from the air conditioning tutorial within OpenCAE.jp ?

If so, there is a bit more information here:
http://www.cfd-online.com/Forums/ope...-openfoam.html

This is a short paper from the same author (Masashi Imano). It does not answer your question, but explains things from a higher level. The paper should have been presented at the Penn State OpenFoam meeting.
http://www.personal.psu.edu/dab143/O..._nomura_ab.pdf

Slides by Keigo Nomura as well:
http://www.personal.psu.edu/dab143/O...ura_slides.pdf

Were you successful running the case?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to calculate mass flow rate on patches and summation of that during the run?	immortality	OpenFOAM Post-Processing	104	February 16, 2021 08:46
[foam-extend.org] problem when installing foam-extend-1.6	Thomas pan	OpenFOAM Installation	7	September 9, 2015 21:53
[swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0	towanda	OpenFOAM Community Contributions	6	September 5, 2015 21:03
"parabolicVelocity" in OpenFoam 2.1.0 ?	sawyer86	OpenFOAM Running, Solving & CFD	21	February 7, 2012 11:44
ParaView Compilation	jakaranda	OpenFOAM Installation	3	October 27, 2008 11:46

April 2, 2013, 19:09		#2
JR22 Senior Member Jose Rey Join Date: Oct 2012 Posts: 134 Rep Power: 17	Did you get that file from the air conditioning tutorial within OpenCAE.jp ? If so, there is a bit more information here: http://www.cfd-online.com/Forums/ope...-openfoam.html This is a short paper from the same author (Masashi Imano). It does not answer your question, but explains things from a higher level. The paper should have been presented at the Penn State OpenFoam meeting. http://www.personal.psu.edu/dab143/O..._nomura_ab.pdf Slides by Keigo Nomura as well: http://www.personal.psu.edu/dab143/O...ura_slides.pdf Were you successful running the case?