 |
 |
 |
|
|
|
[Sponsors] | ||||
June 29, 2016, 09:41
|
layer addition
|
#1 |
|
Member
Almond Wong
Join Date: May 2016
Posts: 68
Rep Power: 9  |
Hi,
i trying to do a mesh around a domain of a city. this can be easily done with snappy function. But in order to make the mesh better, I though of adding layers. At the moment, the layers are weird in the sense that it stop at those sharp edges. Is there anyway to avoid this? Attached is a picture of the different layer effect. The one on the right is what i am aiming for. Any idea how to get to that? |
|
|
|
|
|
June 29, 2016, 14:15
|
|
#2 |
|
Member
Kaufman
Join Date: Jul 2013
Posts: 55
Rep Power: 12 |
Hi,
Increasing the featureAngle entry (which located at sub-dictionary of controls for layer addition) to 130 may work. |
|
|
|
|
|
|
June 29, 2016, 14:21
|
|
#3 |
|
Member
Almond Wong
Join Date: May 2016
Posts: 68
Rep Power: 9 |
hi, Thank you for the reply. But it doesnt solve it. I even tried with 180.
|
|
|
|
|
|
|
June 29, 2016, 15:04
|
|
#4 |
|
Member
Kaufman
Join Date: Jul 2013
Posts: 55
Rep Power: 12 |
Hi,
It will be easier to identify the problem, if you can upload your test case. |
|
|
|
|
|
|
June 29, 2016, 15:09
|
|
#5 |
|
Member
Almond Wong
Join Date: May 2016
Posts: 68
Rep Power: 9 |
Hi, this is the same tutorial as in the picture, i have also attached the file.
|
|
|
|
|
|
 |
| Tags |
| layer |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Help with Snappy: no layers growing | GianF | OpenFOAM Meshing & Mesh Conversion | 2 | September 23, 2020 08:26 |
| [snappyHexMesh] SHM Layer Addition Phase | dickcruz | OpenFOAM Meshing & Mesh Conversion | 4 | November 1, 2018 07:05 |
| [snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 05:53 |
| Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 07:48 |
| errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |
Linear Mode
