|
[Sponsors] |
June 6, 2016, 10:57 |
Cell cutting utility
|
#1 |
New Member
Richard Vega
Join Date: Jun 2014
Location: Texas
Posts: 12
Rep Power: 11 |
I have been looking for a solution online, but all of the options I have found are very confusing. This is what I would like to do:
Split the cells in a given cellSet with the same cutting plane. For instance, I could make a cellSet out of all the cells through which the plane z = 100.0 passes. I would then like to split these cells with that plane, and then write the new mesh to disk. Is there an OpenFOAM utility that can do this for me? I have been looking at meshCutter, which uses cellCuts, but from what I can tell, this only splits each cell using a plane going through the cell centre. |
|
July 4, 2016, 11:01 |
Anyone?
|
#2 |
New Member
Richard Vega
Join Date: Jun 2014
Location: Texas
Posts: 12
Rep Power: 11 |
Does anyone have any ideas? Please....
|
|
Tags |
cellcuts, meshcutter, splitcells |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Neighboring cells in tetrahedral mesh | vishwesh | OpenFOAM Programming & Development | 9 | November 10, 2017 07:06 |
Doubt about parallel processing | vishwesh | OpenFOAM Programming & Development | 0 | November 10, 2017 06:20 |
[General] 2 datas on one plot | Akuji | ParaView | 46 | December 1, 2013 14:06 |
monitoring cell | Jane | Siemens | 2 | March 4, 2004 21:01 |
cell to cell relation | CMB | Siemens | 1 | December 4, 2003 04:05 |