 |
 |
 |
|
|
|
[Sponsors] | ||||
July 1, 2009, 10:44
|
splitMeshRegion
|
#1 |
|
New Member
Kyian Barrat
Join Date: Apr 2009
Posts: 25
Rep Power: 17  |
Hi Foamers,
Im not sure to post the thread in the right place, so, forgive me... Im working on a case where i have 4 regions (3 solids and 1 fluid). So I try to understand chtMultiRegionFoam solver following the same steps as the tutorial multiRegionHeater. But when i run the application splitMeshRegion, it finds only 2 regions (1 solid 1 fluid). It's strange because in the step before (the application setsToZone), it finds 4 Zones. I well defined 4 regions in RegionProperties. I dont know where it can come from... Can someone have an explanation? What I have to do to fix it? Thanks in advance Kyian |
|
|
|
|
|
July 2, 2009, 05:02
|
|
#2 |
|
New Member
Kyian Barrat
Join Date: Apr 2009
Posts: 25
Rep Power: 17 |
Hi,
I found the problem... there was a mistake in the makeCellSet file... Sorry for polluting the forum |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [mesh manipulation] splitMeshRegion | FekrKon | OpenFOAM Meshing & Mesh Conversion | 27 | June 23, 2020 13:57 |
| [Other] splitMeshRegion problem(cell in multi zones) | huangkai | OpenFOAM Meshing & Mesh Conversion | 0 | April 10, 2019 10:52 |
| [mesh manipulation] splitMeshRegion for chtMultiRegionFoamCase | Bob! | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2017 18:08 |
| cht splitMeshRegion but keeping porous cellZones | klilla | OpenFOAM Pre-Processing | 3 | November 19, 2013 08:32 |
| [mesh manipulation] SplitMeshRegion | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 2 | October 29, 2008 06:38 |
Linear Mode
