|May 20, 2010, 01:58||
Join Date: May 2010
Location: Perth, Australia
Posts: 11Rep Power: 8
I am developing a cyclinder with an internal hole, as I run blockMesh command,
The error stated:
Inconsistent number of faces between block pair 0 and 3.
From function blockMesh::createMergeList()
in file createMergeList.C at line 196.
I have check my code and has verified show be ok.
Anyone knows what's the problem?
|May 20, 2010, 11:37||
Join Date: Mar 2009
Posts: 97Rep Power: 10
Have you left your mergePatchPairs empty? For quite a while this function has not been active/working at all, at least for what I can remember in the 1.5 version. I think your best way to do this is to "create" the hole the hard way, instead of subtracting it - if I understand you right.
Considering a pipe you should be careful to always to specify you blocks and patches according to the fig. on p. 134 in the (1.6) manual.
|Thread||Thread Starter||Forum||Replies||Last Post|
|groovyBC||sega||OpenFOAM Running, Solving & CFD||12||February 17, 2010 10:30|
|Installation OF1.5-dev||ttdtud||OpenFOAM Installation||46||May 5, 2009 02:32|
|Problem with compile the setParabolicInlet||ivanyao||OpenFOAM Running, Solving & CFD||6||September 5, 2008 20:50|
|Compiling Netgen on Fedora Core is driving me crazy||jango||Open Source Meshers: Gmsh, Netgen, CGNS, ...||3||November 9, 2007 14:29|
|user defined function||cfduser||CFX||0||April 29, 2006 10:58|