|
[Sponsors] |
February 24, 2011, 18:55 |
run BlockMesh in existing case?
|
#1 |
Member
yu
Join Date: Nov 2010
Posts: 39
Rep Power: 15 |
Hello all,
I am working with a existing case in OpenFoam 1.6. I am running 1.7. I did the necessary steps to have the case running. I do not if I should run the BlockMesh command or not. At the end I would like to modify the BC and the geometry. I already have a *.neu file and can do the NeutralToFoam command, but do I need to run BlockMesh at some point? best, yu |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] can snappy run with multiple block in blockMesh | BakedAlmonds | OpenFOAM Meshing & Mesh Conversion | 9 | November 29, 2018 06:30 |
How to run the 3dTube case in parallel (foam-extend 3.1 with FSI from Zagreb)? | Warlord | OpenFOAM Running, Solving & CFD | 1 | January 27, 2018 14:48 |
chtMultiRegionSimpleFoam planeWall2D case dont run correctly in OPenFOAM 1606+ | shengqiming | OpenFOAM Running, Solving & CFD | 0 | August 7, 2016 14:15 |
Unable to run the case parallel using foam-extend in the cluster | farahaqilah | OpenFOAM | 0 | July 27, 2016 23:49 |
how to map results from steady state run to tranient case? | phsieh2005 | OpenFOAM Running, Solving & CFD | 2 | November 7, 2010 06:20 |