 |
 |
 |
|
|
|
[Sponsors] | ||||
August 2, 2011, 09:11
|
mergePatchPairs problem
|
#1 |
|
New Member
Join Date: Jul 2011
Posts: 18
Rep Power: 14  |
Hi,
I want to merge two pairs of patches which are connected to each other (as in the case discussed here: http://www.cfd-online.com/Forums/ope...o-patches.html With OF 1.7.1, I'm getting the error "Face 167 reduced to less than 3 points. Topological/cutting error B. Old face: 2(192 196) new face: 2(35 71)" from blockMesh when I try to merge both pairs - one alone works well. I wonder if blockMesh is able to deal with this case in version 2.0 - could anybody having this version available please try to run my attached blockMeshDict? Regards, Hugo |
|
|
|
|
|
August 4, 2011, 08:05
|
|
#2 |
|
New Member
Join Date: Jul 2011
Posts: 18
Rep Power: 14 |
I managed to try the case with OF 2.0 - it's the same problem. However, adding an extra cell row and and extra cell column as seperate blocks between the different grid densities solves the problem.
Regards, Hugo |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
| BuoyantBoussinesqSimpleFoam_Facing problem | Mondal131211 | OpenFOAM Running, Solving & CFD | 1 | April 10, 2019 19:41 |
| Mesh& steptime independant: conduction-convection problem | Fati1 | Main CFD Forum | 1 | October 28, 2018 13:52 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Linear Mode
