 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] What is the dimension of "minThickness" in SHM? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 20, 2012, 12:10
|
What is the dimension of "minThickness" in SHM?
|
#1 |
|
Senior Member
Canakkale Dardanelspor
Join Date: Aug 2012
Posts: 135
Rep Power: 13  |
Hi,
Could anyone please tell me what the dimension of "minThickness" under "addLayersControls" in "snappyHexMeshDict" is? Many thanks in advance. |
|
|
|
|
|
October 25, 2012, 04:23
|
|
#2 |
|
Super Moderator
Tobias Holzmann
Join Date: Oct 2010
Location: Tussenhausen
Posts: 2,708
Blog Entries: 6
Rep Power: 51   |
Hi,
normally it should be [m]. If you switch off the "relativeSize" you get an absolute value. If its falls the height of your cells depend on the nearest cells to your BC. Have a look at the snappyHexMesh Wiki and the presentation published this year at the 7th workshop |
|
|
|
|
|
|
October 25, 2012, 07:22
|
|
#3 |
|
Senior Member
Canakkale Dardanelspor
Join Date: Aug 2012
Posts: 135
Rep Power: 13 |
Thanks very much!
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Refinement dimension is not working | Tasos | ANSYS Meshing & Geometry | 0 | May 13, 2017 09:07 |
| [snappyHexMesh] SHM not snapping to some surfaces | Swift | OpenFOAM Meshing & Mesh Conversion | 13 | January 4, 2016 01:56 |
| buoyantPimpleDyMFoam dimension mismatch between Uf and phi | Sumit07 | OpenFOAM Programming & Development | 2 | June 17, 2015 03:55 |
| [snappyHexMesh] SHM: feature edge snapping not conforming | thab | OpenFOAM Meshing & Mesh Conversion | 3 | November 26, 2012 14:04 |
| [snappyHexMesh] sHM with cyclic patch on stl geometry | johannesk | OpenFOAM Meshing & Mesh Conversion | 2 | August 21, 2009 09:08 |
Linear Mode
