 |
 |
 |
|
|
|
[Sponsors] | ||||
March 26, 2015, 08:43
|
Gmsh a mesh at points within a volume
|
#1 |
|
New Member
Reuben Zotz-wilson
Join Date: Mar 2015
Posts: 1
Rep Power: 0  |
Hi all,
I would like to know the best way to refine a mesh based on characteristic length at points within a volume. Obviously I have defined the cl of each point but during meshing these are not adopted since the points are not coincident with the mesh nodes. I have determined that it is possible to refine points within a surface, by embedding, however from what I understand the same is not possible for a volume. Please find attached the corresponding .geo file. Cheers Reuben |
|
|
|
|
 |
| Tags |
| refine mesh, volume |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [snappyHexMesh] SHM Layer Addition Phase | dickcruz | OpenFOAM Meshing & Mesh Conversion | 4 | November 1, 2018 07:05 |
| [snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 03:21 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
| On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
Linear Mode
