|
[Sponsors] |
July 20, 2016, 17:02 |
Surface loop command in Gmsh?
|
#1 |
Member
OpenFoam
Join Date: Jun 2016
Posts: 82
Rep Power: 9 |
Hello All,
I was wondering if some has used the surface loop command to create a 3d mesh. I have been looking through gmsh to get this command, but there are only plane surface and ruled surface, which will not lead to the following; Surface Loop(1) = {1, 2, 3, 4, 5, 6}; Volume(2) = {1}; I was wondering how to get these commands through gmsh. Thanks in advance, |
|
July 20, 2016, 23:27 |
|
#2 |
Member
OpenFoam
Join Date: Jun 2016
Posts: 82
Rep Power: 9 |
This was as silly question.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How To Create Fowcs William Hawkings Surface in Fluent? | marinkobezu | FLUENT | 7 | October 25, 2018 10:51 |
[Gmsh] Converting gmsh to OpenFoam | Friendly | OpenFOAM Meshing & Mesh Conversion | 3 | June 26, 2018 05:46 |
GMSH Boundary layer randomly create cells inside surface | tomm450 | Mesh Generation & Pre-Processing | 0 | February 10, 2018 05:34 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
GMSH - Very strange effect - Mesh elements deleted when saving | Araist | Mesh Generation & Pre-Processing | 3 | July 15, 2015 06:03 |