 |
 |
 |
|
|
|
[Sponsors] | ||||
July 12, 2010, 22:24
|
Hexahedral mesh generation
|
#1 |
|
New Member
makoto honda
Join Date: Jul 2010
Posts: 3
Rep Power: 15  |
I have created a hexahedral grid generation software in Windows. This is an initial proof of concept implementation. I created a volume mesh directly - i.e., without going from Edge-Surface-Volume. I wonder if this approach is something new or noteworthy. I described it at www.iNet1000.com.
Right now, I am only supporting domains made of "line" edges. That is, the edge type is just a straight line only. I believe eventually it can be extended to ARC, SPLINE, etc... I am not a CFD expert. I have a limited exposure to CFD, but I do have an extensive experiense in CAD and graphics area. M |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water! | divergence | OpenFOAM Meshing & Mesh Conversion | 0 | January 23, 2019 04:17 |
| [ANSYS Meshing] generation hexahedral mesh type in ANSYS meshing | zryan civil | ANSYS Meshing & Geometry | 1 | July 21, 2016 14:54 |
| New Mesh Generation and Pre-Processing Forums | pete | Site News & Announcements | 2 | December 26, 2012 17:56 |
| Hexahedral Mesh Generation software | makotohonda | Main CFD Forum | 1 | July 14, 2010 00:04 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Linear Mode
