|October 28, 2010, 02:49||
gmshToFoam: patch vs wall
I have recently trying to convert Gmsh mesh to OpenFoam with relatively good success so far.
I recently try using the simpleFoam solver (turbulence) and run into the following problem:
The boundaries defined in Gmsh are converted to Patch in openFoam. Although it is good for inlet/outlet, wall with wall function require the type to be set to Wall.
Is there a way (other than manually editing the constant/Boundary file) to convert Patch into Wall (or get gmshToFoam to do it)?
Thanks in advance
|Thread||Thread Starter||Forum||Replies||Last Post|
|CGNS converters available||mbeaudoin||OpenFOAM Meshing & Mesh Conversion||132||January 19, 2017 17:17|
|Patch which extrapolates pressure to a wall||steph79||OpenFOAM Pre-Processing||1||October 9, 2010 16:31|
|Create boundary||fabrizio||Open Source Meshers: Gmsh, Netgen, CGNS, ...||1||October 26, 2008 15:12|
|GmshToFoam undefined faces||derath||Open Source Meshers: Gmsh, Netgen, CGNS, ...||7||May 22, 2006 04:54|
|Import gmsh msh to Foam||adorean||Open Source Meshers: Gmsh, Netgen, CGNS, ...||24||April 27, 2005 08:19|