[blockMesh] 2d axisymmeric mesh for coaxial pipes

gian87 · October 3, 2014, 17:45

I want to simulate the flow through the annular space between two pipes of different diameters (lets say d i D, respectively, with a length of L). In Fluent, it is possible to define such a system as a 2d axisymetric case.

My question is: how can I accomplish this using OpenFOAM? How should I configure the blockMeshDict file to achieve that? According to the User Guide, the solution for the typical 2d axissymetric case is to use wedge patches and a block with only 6 vertices, while the axis is defined by the "merged" vertices. I understand this approach, but how should I define the axis when it is actually outside the domain (as I will not simulate any flow in the lumen of the inner pipe)?

zandi · October 5, 2014, 19:16

You can use snapyHexMesh. First use blockMesh for draw outer pipe with arc (edges in blockMeshDict). Then draw inner pipe with cad in .stl format. After that use snapyHex Mesh in order to cute the inner pipe's shape out from the outer one.
Wedge BC help you to simulate just a circular sector of your axi-symmetric geometry if it has the condition.

October 3, 2014, 17:45	2d axisymmeric mesh for coaxial pipes	#1
gian87 New Member Join Date: Oct 2014 Posts: 1 Rep Power: 0	I want to simulate the flow through the annular space between two pipes of different diameters (lets say d i D, respectively, with a length of L). In Fluent, it is possible to define such a system as a 2d axisymetric case. My question is: how can I accomplish this using OpenFOAM? How should I configure the blockMeshDict file to achieve that? According to the User Guide, the solution for the typical 2d axissymetric case is to use wedge patches and a block with only 6 vertices, while the axis is defined by the "merged" vertices. I understand this approach, but how should I define the axis when it is actually outside the domain (as I will not simulate any flow in the lumen of the inner pipe)?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters)	shubham jain	ANSYS Meshing & Geometry	1	April 10, 2017 05:03
[snappyHexMesh] Snappyhex mesh: poor inlet mesh	Swagga5aur	OpenFOAM Meshing & Mesh Conversion	1	December 3, 2016 16:59
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

October 5, 2014, 19:16		#2
zandi Senior Member Fatema Zandi Goharrizi Join Date: Mar 2009 Posts: 158 Rep Power: 17	You can use snapyHexMesh. First use blockMesh for draw outer pipe with arc (edges in blockMeshDict). Then draw inner pipe with cad in .stl format. After that use snapyHex Mesh in order to cute the inner pipe's shape out from the outer one. Wedge BC help you to simulate just a circular sector of your axi-symmetric geometry if it has the condition.