|
[Sponsors] |
July 6, 2012, 10:57 |
Conical Mesh with blockMesh?
|
#1 |
Member
Join Date: Sep 2011
Posts: 45
Rep Power: 14 |
Is there a way to create a conical volume with blockMesh ?
Then, would it be possible to impose only a couple a value (U for example) on the outer boundary (circle) ? Thank you |
|
July 8, 2012, 10:06 |
|
#2 |
Member
Join Date: Sep 2011
Posts: 45
Rep Power: 14 |
Ok I found an example of meshing here :
http://openfoamwiki.net/index.php/Si...nical_diffuser However, I would like to prescribe radial velocities on the sides of the cone (not the "inlet" and "outlet"). Is there an existing boundary condition that I can use to impose radial velocities in spherical coordinates ? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 16:59 |
Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |