 |
 |
 |
|
|
|
[Sponsors] | ||||
September 8, 2016, 05:17
|
Problem with snappyHexMesh
|
#1 |
|
New Member
Francesco
Join Date: May 2012
Location: italy
Posts: 8
Rep Power: 13  |
Hi everyone,
I'm a new in OF, and i've got some problem to mesh a really simple geometry. I'm trying to simulate the primary break-up of a liquid jet for my PhD thesis. Usualy i use the commercial code CSI converge to perform ICE and break-up simulations, and this is my first approach to an opensource CFD. The geometry consists in a cylinder with 0.2 mm of radius and 0.6 mm height, attached to a box 1x1x2 mm. I would obtain a full hex cut cell mesh so i can compare with the Converge results. I tryed to follow many tutorials but i don't know what is wrong. I attach you the complete case. Could anyone help me?? Thank you so Much Francesco |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Problem with decomposePar, snappyHexMesh | luca1992 | OpenFOAM Meshing & Mesh Conversion | 12 | August 23, 2017 19:06 |
| [snappyHexMesh] snappyHexMesh problem | cfdsolver1 | OpenFOAM Meshing & Mesh Conversion | 0 | June 23, 2016 10:09 |
| [snappyHexMesh] Problem handling with subdictionary in SnappyHexMesh | Lorenzo92 | OpenFOAM Meshing & Mesh Conversion | 0 | November 21, 2015 13:57 |
| [snappyHexMesh] Problem with snappyhexMesh: modelling a pore chamber and pore throat model | Saideep | OpenFOAM Meshing & Mesh Conversion | 5 | May 10, 2015 14:46 |
| [snappyHexMesh] Problem with snappyHexMesh | giack | OpenFOAM Meshing & Mesh Conversion | 2 | September 18, 2014 10:03 |
Linear Mode
