|
[Sponsors] |
[Commercial meshers] Non-Orthogonal faces problem- Pointwise export to OpenFOAM |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 10, 2013, 08:00 |
Non-Orthogonal faces problem- Pointwise export to OpenFOAM
|
#1 |
New Member
Milad MU
Join Date: Feb 2013
Posts: 9
Rep Power: 13 |
Hi guys,
I am working on a complicated terrain. I have used pointwise to mesh the geometry and when I export to OpenFOAM it gives me warning about non-orthogonal faces. I have created almost 60M cells in one block and my terrain is the bottom of this cube. around 9000 non-orthogonal faces are found. Any idea how to solve this problem? how do you reduce non-orthogonal faces in your cases? Of course I can run the case but the results are not reasonable. In addition, I have used structured mesh. BR Milad |
|
February 11, 2014, 12:03 |
|
#2 |
Member
Ye Zhang
Join Date: Dec 2009
Location: Delft,Netherland
Posts: 92
Rep Power: 16 |
Hi Milad,
Did you find the solution? I have the same problem. Thank you very much! Best regards, Ye |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[OpenFOAM.org] OF2.3.1 + OS13.2 - Trying to use the dummy Pstream library | aylalisa | OpenFOAM Installation | 23 | June 15, 2015 14:49 |
SigFpe when running ANY application in parallel | Pj. | OpenFOAM Running, Solving & CFD | 3 | April 23, 2015 14:53 |
Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 15:03 |
[Commercial meshers] Handling cyclic BC from gambit to openfoam for a cascade airfoil problem - OF 1.6 | maverick | OpenFOAM Meshing & Mesh Conversion | 2 | June 18, 2011 04:36 |