[mesh manipulation] Moving Mesh

mehdi.en · May 5, 2015, 09:03

Dear Foamers;
I am going to simulate deformation of a rubber pipe when a newtonian fluid (water) is flowing through. The pipe is considered viscoelastic. I want to know how could I create mesh (is the movingMesh utility appropriate?) and what type of mesh shall I use (is the movingMesh ok? Or I should use a meshless approach?)? What boundary conditions should I use? Which type of applications is the best for this problem?
Thanks in advance
Mehdi

Mojtaba.a · December 13, 2015, 14:08

Well Dear Mehdi,

You have asked a very general question! You have to be very more specific about what you are doing and what exactly is the geometry of your problem.
Your problem is a FSI problem and not actually very easy to get over with. First of all you have to have a good understanding of OpenFOAM FSI solvers, try solving some simple tutorials and then may try it on your own problem. You may take a look at this video:
https://www.youtube.com/watch?v=Te9LCqPgT-Q

Best.

May 5, 2015, 09:03	Moving Mesh	#1
mehdi.en New Member Mehdi Join Date: May 2015 Posts: 1 Rep Power: 0	Dear Foamers; I am going to simulate deformation of a rubber pipe when a newtonian fluid (water) is flowing through. The pipe is considered viscoelastic. I want to know how could I create mesh (is the movingMesh utility appropriate?) and what type of mesh shall I use (is the movingMesh ok? Or I should use a meshless approach?)? What boundary conditions should I use? Which type of applications is the best for this problem? Thanks in advance Mehdi

December 13, 2015, 14:08		#2
Mojtaba.a Senior Member Mojtaba Amiraslanpour Join Date: Jun 2011 Location: Tampa, US Posts: 308 Rep Power: 15	Well Dear Mehdi, You have asked a very general question! You have to be very more specific about what you are doing and what exactly is the geometry of your problem. Your problem is a FSI problem and not actually very easy to get over with. First of all you have to have a good understanding of OpenFOAM FSI solvers, try solving some simple tutorials and then may try it on your own problem. You may take a look at this video: https://www.youtube.com/watch?v=Te9LCqPgT-Q Best. msuaeronautics likes this. __________________ Learn OpenFOAM in Persian SFO (StarCCM+ FLUENT OpenFOAM) Project Team Member Complex Heat & Flow Simulation Research Group If you can't explain it simply, you don't understand it well enough. "Richard Feynman"

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
Trying to set up Moving Mesh Problem	dreamchaser	CFX	5	December 15, 2014 00:07
snappyhexmesh remove blockmesh geometry	philipp1	OpenFOAM Running, Solving & CFD	2	December 12, 2014 10:58
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 19:43