[Commercial meshers] How to set an interior boundary type in OF?

liu.zhen · December 18, 2009, 00:32

Hi,

I imported a 3d fluent mesh file (.msh) to openfoam. There are some internal faces that I want to define as interior boundary type, how should I define boundary file in folder "/constant/polyMesh"; and how to give type and value to U, p or other scalars in folder "0/" ?

aldo.iannetti · June 8, 2010, 10:32

Hi
I have the same problem,
Did you resolve it? How?
thanks
Aldo

Quote:

Originally Posted by liu.zhen

Hi,

I imported a 3d fluent mesh file (.msh) to openfoam. There are some internal faces that I want to define as interior boundary type, how should I define boundary file in folder "/constant/polyMesh"; and how to give type and value to U, p or other scalars in folder "0/" ?

liu.zhen · June 11, 2010, 01:20

well, I tried some time, but failed

It seems to me the "interior" bc is not accepted by openfoam.

mrshb4 · December 26, 2010, 13:08

Hi
I had the same proble but it was solved. just follow this thread, I describe it there.

http://www.cfd-online.com/Forums/ope...tml#post287899

Have fun.
Mohammadreza

December 18, 2009, 00:32	How to set an interior boundary type in OF?	#1
liu.zhen New Member Join Date: May 2009 Posts: 4 Rep Power: 16	Hi, I imported a 3d fluent mesh file (.msh) to openfoam. There are some internal faces that I want to define as interior boundary type, how should I define boundary file in folder "/constant/polyMesh"; and how to give type and value to U, p or other scalars in folder "0/" ?

December 26, 2010, 13:08	follow the link!	#4
mrshb4 Member Mohammad.R.Shetab Join Date: Jul 2010 Posts: 49 Rep Power: 15	Hi I had the same proble but it was solved. just follow this thread, I describe it there. http://www.cfd-online.com/Forums/ope...tml#post287899 Have fun. Mohammadreza

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
reactingMultiphaseEulerFoam	tonnykz	OpenFOAM Running, Solving & CFD	2	June 15, 2020 02:09
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries	NickG	OpenFOAM Installation	3	December 30, 2019 00:21
Modified pimpleFoam solver to MRFPimpleFoam solver	hiuluom	OpenFOAM Programming & Development	12	June 14, 2015 21:22
interFoam/kOmegaSST tank filling with printStackError/Mules	simpomann	OpenFOAM Running, Solving & CFD	3	February 17, 2014 17:06
singularity?	mihaipruna	OpenFOAM Running, Solving & CFD	5	April 24, 2012 17:18

June 11, 2010, 01:20		#3
liu.zhen New Member Join Date: May 2009 Posts: 4 Rep Power: 16	well, I tried some time, but failed It seems to me the "interior" bc is not accepted by openfoam.