|
[Sponsors] |
[Gmsh] GMsh - 2D working fine. 3D will not resolve. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 27, 2013, 15:44 |
GMsh - 2D working fine. 3D will not resolve.
|
#1 |
New Member
Philip Brown
Join Date: Jun 2013
Posts: 25
Rep Power: 12 |
I have created a wing in a control volume and the 2D meshing looks all good but doesn't seem to want to mesh in 3D. I sat for about an hour as it kept working but didn't give a 3D mesh.
Here is a pic of the .geo with a 2D mesh on it and here is the .geo file. I tried to use the other 3D meshers but it also says that tetgen is not compile for gmsh. Any help would be greatly appreciated. Last edited by Phizz82; August 27, 2013 at 17:49. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
waveDyMFoam stability issue | goodster | OpenFOAM Running, Solving & CFD | 6 | September 23, 2018 04:40 |
Gmsh mesh generator error | tamminj3 | Electromagnetics | 0 | March 5, 2018 07:10 |
centOS 5.6 : paraFoam not working | yossi | OpenFOAM Installation | 2 | October 9, 2013 01:41 |
Interfoam blows on parallel run | danvica | OpenFOAM Running, Solving & CFD | 16 | December 22, 2012 02:09 |
[Gmsh] problem converting mesh from gmsh | Fried | OpenFOAM Meshing & Mesh Conversion | 8 | October 18, 2011 08:53 |