|July 25, 2012, 18:09||
Can't get simple STL file to mesh
Join Date: Jun 2012
Location: Oxfordshire, UK
Posts: 2Rep Power: 0
My intention is to set-up an aerofoil (original I know!) using snappyHexMesh but I'm having no end of trouble. I've attached a very basic STL file which I've tried to import but I get the error:
--> FOAM FATAL ERROR:
Faces do not seem to be correct across coupled boundaries
Coupled face 9497282 on patch 0 allBoundary coords:4((-0.97 0.1 -0.09) (-0.97 0.1 -0.085) (-0.965 0.1 -0.085) (-0.965 0.1 -0.09)) has face area:2.5e-05 (coupled) neighbour face area differs:1.25e-05 to within tolerance 2.24499e-06
From function hexRef8::checkMesh()
in file polyTopoChange/polyTopoChange/hexRef8.C at line 4489.
I've had some success with a sphere imported from STL but no joy with this rough wing section.
Any help would be appreciated!
|Thread||Thread Starter||Forum||Replies||Last Post|
|groovyBC in openFOAM-2.0 for parabolic velocity bc||ofslcm||OpenFOAM Pre-Processing||24||August 23, 2015 22:41|
|Moving mesh||Niklas Wikstrom (Wikstrom)||OpenFOAM Running, Solving & CFD||122||June 15, 2014 06:20|
|close stl file, inflow calculation, how to generete mesh?||lixuethermal||OpenFOAM Meshing & Mesh Conversion||3||November 9, 2011 07:05|
|OpenFOAM on MinGW crosscompiler hosted on Linux||allenzhao||OpenFOAM Installation||127||January 30, 2009 20:08|
|PHI file structure||Eugene||Phoenics||9||November 2, 2001 23:00|