 |
 |
 |
|
|
|
[Sponsors] | ||||
May 5, 2013, 21:25
|
About non-closed surface
|
#1 |
|
Senior Member
Dongyue Li
Join Date: Jun 2012
Location: Beijing, China
Posts: 838
Rep Power: 17  |
Hi snappy Meshers!
Recently I run into many times that snappy says" its not closed".I tried to make a cylinder via CATIA,ICEM,AC3D.(a cylinder is easy to draw),Only AC3D's cylinder is closed. But why CATIA and ICEM's cylinder have problems? I often use refinement,so I have to make the cylinder closed.anyone know how to make ICEM's cylinder closed?cuz I am not familar with AC3D anyway~ Tnanks in advance. |
|
|
|
|
|
May 6, 2013, 01:04
|
|
#2 |
|
Member
Akshay Kumar
Join Date: Aug 2010
Location: India
Posts: 84
Rep Power: 15 |
Hi Forrest
Check modelling tolerances as this varies for different applications. Ak |
|
|
|
|
|
|
May 6, 2013, 02:16
|
|
#3 | |
|
Senior Member
Dongyue Li
Join Date: Jun 2012
Location: Beijing, China
Posts: 838
Rep Power: 17 |
Quote:
I dont know how to do this.I upload a simple cylinder made by ICEM. Could you help me to check this out? Thanks. |
||
|
|
|
||
|
May 9, 2013, 03:27
|
|
#4 |
|
Member
Akshay Kumar
Join Date: Aug 2010
Location: India
Posts: 84
Rep Power: 15 |
Hey
surfaceCheck on your STL says that it is not closed. There are possible gaps where the edges connect. Ak |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SampledSurface, can't find closed walk around surface | nikwin | OpenFOAM | 4 | September 23, 2020 09:46 |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
| [snappyHexMesh] Layers don't fully surround surface | EVBUCF | OpenFOAM Meshing & Mesh Conversion | 14 | August 20, 2012 04:31 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
Linear Mode
