snappyHexMesh uses tet cells for internal mesh!
3 Attachment(s)
Hi Foamers,
I have a question about snappyhexmesh. Actually I have used this utility several times. I think it is possible to create hexa cells on boundary faces but for internal mesh this utility uses tetra cells. For example, Take a look at igloo test case (version 2.2.2). There are some hexa cells on boundary faces (picture1) but when I create a slice I can not find any hexa cells!!!(picture2) :confused: (Please correct me if I am wrong). How can I create hexa cells for internal mesh by using snappyhexmesh ? I appreciate your help. Best regards, Sasan. |
Quick answer:
|
Dear Bruno,
I got it. Thank you very much Best regards. |
All times are GMT -4. The time now is 02:49. |