CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (https://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   [surface handling] surfaceFeatureExtract in Foam Extend 3.2 (https://www.cfd-online.com/Forums/openfoam-meshing/193971-surfacefeatureextract-foam-extend-3-2-a.html)

ashish.svm October 7, 2017 21:08
surfaceFeatureExtract in Foam Extend 3.2
 
I am facing a problem with surfaceFeatureExtract in Foam Extend 3.2

I am using the following command

surfaceFeatureExtract -includedAngle 150 -writeObj constant/triSurface/geom.stl

But it shows this error

--> FOAM FATAL ERROR:
Wrong number of arguments, expected 2 found 1
Invalid option: -writeObj

Katt October 12, 2017 04:53
Hi,
Have you found out how to do this. I am in need of the same for foam-Extend 1.6.

ashish.svm October 12, 2017 08:54
Quote:
Originally Posted by Katt (Post 667590)
Hi,
Have you found out how to do this. I am in need of the same for foam-Extend 1.6.
No, I could not figure it out in foam extend version. But I installed OpenFOAM 4.0 and then got it working with surfaceFeatureExtractDict in system folder and then in the command you have to run surfaceFeatureExtract


All times are GMT -4. The time now is 17:29.