 |
 |
 |
|
|
|
[Sponsors] | ||||
March 18, 2019, 12:03
|
refineWallLayer vs add layer
|
#1 |
|
Member
Andrew
Join Date: Mar 2018
Posts: 82
Rep Power: 8  |
Hi guys, i would kinldy ask you for some information.
1) how could i see on paraview the distribution of the layers obtained with "refineWallLayer" in the same way as done with the utility "nSurfaceLayers" when the layers are added with the "layer" option in snappyHexMesh? 2) which is the difference between adding layers with "refineWallLayer" and "add layer" ? 3) does the value of the y+ change when using layers obtained with "refineWallLayer" instead of "add layers" ? 4) which is the best way to add layers? "refineWallLayers" or "add layers" thanks for the time spent for reading the post Astan |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 05:53 |
| [snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
| [snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
| Add a layer of cells, dynamic mesh or ...? | Modisa | FLUENT | 1 | March 12, 2007 02:01 |
| errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |
Linear Mode
