[snappyHexMesh] Ship hull using snappyHexMesh

nuovodna · August 27, 2010, 05:52

Hi, i made a mesh around a ship hull using snappyHexMesh. The "checkMesh" returns me a warning on 2 non-orthogonal faces (with checkMesh on 1.6 i had no warning). I started the simulation but it fails with a Floating point exception error. Have you any idea??

This is the case

http://ubuntuone.com/p/E1i/

Regards

Emanuele

openfoam_user · June 28, 2011, 10:45

Is it possible to use this combination of applications for free surface calculation :

blockMesh
refineMesh (only in Z-direction)
snappyHexMesh

When I launch sHM i get the following error message:
--> FOAM FATAL ERROR:
cell 72260 of level 0 uses more than 8 points of equal or lower level
Points so far:8(74396 74397 74497 74498 79547 79548 79648 79649)

Regards,

Stephane

August 27, 2010, 05:52	Ship hull using snappyHexMesh	#1
nuovodna Senior Member Emanuele Join Date: Mar 2009 Posts: 110 Rep Power: 17	Hi, i made a mesh around a ship hull using snappyHexMesh. The "checkMesh" returns me a warning on 2 non-orthogonal faces (with checkMesh on 1.6 i had no warning). I started the simulation but it fails with a Floating point exception error. Have you any idea?? This is the case http://ubuntuone.com/p/E1i/ Regards Emanuele

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh Ship Hull with Appendages Problem	bizzy	OpenFOAM Meshing & Mesh Conversion	7	December 14, 2017 16:22
Ship hull with appendage as seperate patch runs into error	manoj_nav	OpenFOAM Running, Solving & CFD	1	March 13, 2016 09:12
How to output the water resistance on a Ship hull	Sachin m	OpenFOAM Post-Processing	1	January 26, 2015 12:24
Free surface comes above the hull of the ship	Sachin m	OpenFOAM Pre-Processing	0	September 4, 2014 00:08
Error in meshing a Ship hull using snappyhexmesh	Sachin m	OpenFOAM Pre-Processing	1	August 27, 2014 23:27

June 28, 2011, 10:45		#2
openfoam_user Senior Member stephane sanchi Join Date: Mar 2009 Posts: 314 Rep Power: 18	Is it possible to use this combination of applications for free surface calculation : blockMesh refineMesh (only in Z-direction) snappyHexMesh When I launch sHM i get the following error message: --> FOAM FATAL ERROR: cell 72260 of level 0 uses more than 8 points of equal or lower level Points so far:8(74396 74397 74497 74498 79547 79548 79648 79649) Regards, Stephane