|September 16, 2010, 12:04||
BC patchs on mesh with snappyhexmesh
Join Date: Apr 2010
Posts: 122Rep Power: 8
I am trying to mesh a pipe joint. Blockmesh gives bad cells which are blowing my solution. I was thinking of snappyHexMesh. But i am not sure whether one can apply BC patches to the surface that you mesh using snappyHexMesh. To be more specific, i would be importing pipe surface stl file and mesh it internally using sHM. but can i assign inlet outlet wall etc BC patches on the pipe surface??? How to do that if at all its possible.??
Imagination is more important than knowledge..
|Thread||Thread Starter||Forum||Replies||Last Post|
|3D Hybrid Mesh Errors||DarrenC||ANSYS Meshing & Geometry||11||August 5, 2013 06:42|
|engrid -> save as .stl with boundarie codes||Zymon||enGrid||31||August 29, 2011 13:40|
|Meshing aifoil in ICEM||student123a||ANSYS Meshing & Geometry||13||December 8, 2010 11:40|
|SnappyHexMesh not generate mesh first time||mavimo||OpenFOAM Mesh Utilities||4||August 26, 2008 07:08|
|basic of mesh refinement||arya||CFX||4||June 19, 2007 12:21|