|December 31, 2010, 18:29||
Extract one face of a sHM-mesh
Join Date: Dec 2010
Posts: 5Rep Power: 8
i use openFoam to calculate drag and lift from airfoils which were created in Matlab.
Is there any way to extract a face/patch of a sHM-mesh?
Because the sHM can generate an fine grid with boundarylayer, but i need only a 2D mesh. So I would extract a face and extrude it to a "3d"-mesh with "empty"-boundaries. It would save a lot resources, and time.
Thanks, a lot!
Last edited by emjay; January 1, 2011 at 09:05. Reason: specify
|January 5, 2012, 07:03||
Join Date: Dec 2011
Posts: 11Rep Power: 7
Check this link:
For OF 1.7 it should work, but I have not been able to run it in OF 2.01.
|airfoil shm 2d|
|Thread||Thread Starter||Forum||Replies||Last Post|
|BlockMesh FOAM warning||gaottino||OpenFOAM Native Meshers: blockMesh||7||July 19, 2010 14:11|
|[GAMBIT] Changing Face mesh color||ibuki||ANSYS Meshing & Geometry||1||June 7, 2010 01:24|
|[GAMBIT] Reversing surface normals for a face mesh?||enfinity||ANSYS Meshing & Geometry||5||March 4, 2010 07:18|
|Import problem||ARC||Open Source Meshers: Gmsh, Netgen, CGNS, ...||0||February 27, 2010 11:56|
|Converting meshes that includes interfaces||ham||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||29||January 8, 2007 09:58|