CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (https://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   [snappyHexMesh] Snap the mesh from a level set function instead of a STL surface (https://www.cfd-online.com/Forums/openfoam-meshing/85930-snap-mesh-level-set-function-instead-stl-surface.html)

ginette March 9, 2011 15:45
Snap the mesh from a level set function instead of a STL surface
 
Dear everyone,

Is it possible to use snappyHexMesh to cut a mesh at the location of the zero-level-set of some volScalarField?

Thanks a lot for your help,
Martin.

eysteinn April 5, 2011 05:38
I'm also looking if there is some built in tool for this.

Did you get an answer to this question?

ginette April 5, 2011 10:21
Sadly not...


All times are GMT -4. The time now is 19:52.