|February 16, 2012, 06:07||
sHM layers problem
Join Date: Jan 2012
Posts: 7Rep Power: 7
I am struggling to with layers in snappyHexMesh.
I have a simple model, from which I am trying to grow 6 layers. In areas close to where the surface refinement changes, the number of grown layers reduces, or disappear altogether. The attached shows an example of this (using ExtractCellsByRegion in paraView).
I also attach the snappyHexMeshDict.
I have tried changing most of the layers settings, but dont really get anywhere.
I would much appreciate any advice!
|Thread||Thread Starter||Forum||Replies||Last Post|
|conduction problem||venkataramana||OpenFOAM||3||December 1, 2013 08:30|
|Problem Importing Geometry ProE to CFX||fatb0y||CFX||3||January 14, 2012 20:42|
|area does not match neighbour by ... % -- possible face ordering problem||St.Pacholak||OpenFOAM||9||November 22, 2011 11:02|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|