|
[Sponsors] |
June 25, 2012, 04:36 |
length of recirculation zone
|
#1 |
New Member
abc
Join Date: Jun 2012
Posts: 4
Rep Power: 13 |
hi,
i was examining the velocity flow pattern and recirculation zones in a t-junction with two different meshing(one a coarser one and the other is the finer one) in fluent. But i am facing a problem in fluent that the length of recirculation zone with coarser grid is more reasonable than that with finer grid at same reynolds number. All the operating conditions as well as grid parameters have been kept same except the extent of meshing(fine and coarse). Please help me out. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam) | Aadhavan | OpenFOAM Meshing & Mesh Conversion | 2 | March 8, 2018 01:47 |
[mesh manipulation] refineMesh Error | mohsen.boojari | OpenFOAM Meshing & Mesh Conversion | 3 | March 1, 2018 22:07 |
how to calculate recirculation length after square cylinder | khalid.elserfy | Main CFD Forum | 1 | August 17, 2015 02:30 |
[GAMBIT] length of recirculation zone | abc | ANSYS Meshing & Geometry | 1 | June 26, 2012 03:12 |
Recirculation length | Tony Chen | Main CFD Forum | 4 | March 4, 1999 12:33 |