 |
 |
 |
|
|
|
[Sponsors] | ||||
May 21, 2006, 03:32
|
3D mesh with boundary layer
|
#1 |
|
Senior Member
Francesco Del Citto
Join Date: Mar 2009
Location: Zürich Area, Switzerland
Posts: 237
Rep Power: 18  |
Hi!
I need to generate a quite complex 3D mesh, with prismatic boundary layer on some surface. As the ratio between width and height of boundary layer cells is about 7/1, the pyramid/tet mesh growing froma the side of such boundary layer can be of very poor quality. Moreover, the meshing algorithm could even fail in such situation. Is there an alternative way to deal with this kind of meshes? Francesco |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
| Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
Linear Mode
