|November 26, 2005, 05:22||
Dear all, can anybody help me
Join Date: Mar 2009
Location: Neuburg/Do., Germany
Posts: 4Rep Power: 10
can anybody help me on how the stitchmesh utility works ?
I've tried to create a hex gmsh mesh in order to understand. The mesh has been imported with gmshToFoam and the patches created look quite reasonable in paraFoam.
Executing "stitchmesh . stitchtest patch4 patch3
-partial" leads to an error message
"--> FOAM FATAL ERROR : Face 3683 reduced to less than 3 points. Topological/cutting error B.
Old face: 1(10) new face: 1(10)
I'll try to attach the case here.
Any help is appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|MergeMesh and stitchMesh||lr103476||OpenFOAM Running, Solving & CFD||40||June 1, 2015 10:07|
|StitchMesh on two patches||anita||OpenFOAM Native Meshers: blockMesh||31||April 4, 2013 11:51|
|StitchMesh on OF15 error any fix||flo||OpenFOAM Bugs||0||August 20, 2008 10:27|
|Using stitchMesh for two pairs of patches||kati||OpenFOAM Mesh Utilities||4||May 24, 2006 02:04|
|GMSH Meshes||rbw||OpenFOAM Pre-Processing||5||September 26, 2005 04:20|