CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Meshing Format & General Technical (
-   -   removing the 'hole' close to the axis (

niklas March 17, 2009 08:29

removing the 'hole' close to the axis
1 Attachment(s)
I have a mesh with a hole in the center.
I tried just moving the points towards the axis. which created other problems, like
zero area faces. No surprise really.

I suspect that I also need to loop over the faces and change the connectivity.
Will this be sufficient though?

If so, any example here of how to reconstruct the mesh with the new faces and points would be appreciated.


mattijs March 18, 2009 04:03

Tried collapseEdges?

niklas March 23, 2009 05:48


Originally Posted by mattijs (Post 209854)
Tried collapseEdges?

yes, but its either core-dumping or producing really crappy meshes.
Probably because I dont know how to use it :)

All times are GMT -4. The time now is 13:23.