|
[Sponsors] |
[Technical] removing the 'hole' close to the axis |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 17, 2009, 07:29 |
removing the 'hole' close to the axis
|
#1 |
Super Moderator
Niklas Nordin
Join Date: Mar 2009
Location: Stockholm, Sweden
Posts: 693
Rep Power: 29 |
I have a mesh with a hole in the center.
I tried just moving the points towards the axis. which created other problems, like zero area faces. No surprise really. I suspect that I also need to loop over the faces and change the connectivity. Will this be sufficient though? If so, any example here of how to reconstruct the mesh with the new faces and points would be appreciated. N |
|
March 18, 2009, 03:03 |
|
#2 |
Senior Member
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,419
Rep Power: 26 |
Tried collapseEdges?
|
|
March 23, 2009, 04:48 |
|
#3 |
Super Moderator
Niklas Nordin
Join Date: Mar 2009
Location: Stockholm, Sweden
Posts: 693
Rep Power: 29 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Wierd behaviour of blockMesh creating axis in wedge | rcastilla | OpenFOAM Meshing & Mesh Conversion | 1 | December 4, 2018 06:24 |
FLUID THROUGH A HOLE (2D) interFoam | AmélieO | OpenFOAM Running, Solving & CFD | 0 | January 17, 2018 17:25 |
[snappyHexMesh] crash sHM | H25E | OpenFOAM Meshing & Mesh Conversion | 11 | November 10, 2014 11:27 |
[Other] dynamic Mesh with angular velocity not parallel to x axis | donQi | OpenFOAM Meshing & Mesh Conversion | 5 | October 2, 2014 23:19 |
Axis treatment in axisymmetrical problem | Jakob1 | OpenFOAM Pre-Processing | 2 | August 25, 2014 03:09 |