|March 23, 2009, 11:45||
2D foam mesh and internal points
Join Date: Mar 2009
Posts: 52Rep Power: 10
I have imported a 2D mesh from Fluent into OpenFoam and everything ran fine: the 2D mesh was transformed in a 3D mesh by extruding one cell in the 3rd direction.
My question is: in this case, are there any internal points? Are the points of the empty patches considered as internal points or not? Are all the points boundary points?
Thank you for your help
|February 28, 2014, 01:05||
Join Date: Oct 2012
Posts: 4Rep Power: 6
I run blockMesh for cavity flow copied from OpenFOAM tutorials and checked generated points, faces and boundary files. I found that some of the faces in the faces file are not real faces, e.g., 4(21 462 463 22). Can you check please? Do you guys know the relations among neighbour, owner, points, faces, and boundary files? I know points file lists all points in the mesh, faces file contains all faces described by the points in points file, boundary file gives the type of boundaries and the number of faces and the number of the start face for each type in the faces file. How about owner and neighbour files? Thanks a lot.
|openfoam mesh files|
|Thread||Thread Starter||Forum||Replies||Last Post|
|BlockMesh FOAM warning||gaottino||OpenFOAM Native Meshers: blockMesh||7||July 19, 2010 14:11|
|TGridFluent mesh with internal by prism layer and internal face for diagnostic||sponiar||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||March 30, 2009 15:02|
|BlockMeshmergePatchPairs||hjasak||OpenFOAM Native Meshers: blockMesh||11||August 15, 2008 07:36|
|Several problems with the mesh conversion utility when converting the meshes from Gridgen||su_junwei||OpenFOAM Meshing & Mesh Conversion||2||July 26, 2008 23:58|
|Clustering points in Elliptic mesh||Doctor Blade||Main CFD Forum||3||October 16, 2004 11:01|