 |
 |
 |
|
|
|
[Sponsors] | ||||
August 27, 2010, 03:25
|
Prism mesh format
|
#1 |
|
New Member
neri alamanni
Join Date: Nov 2009
Posts: 4
Rep Power: 16  |
Hi all
i would like use prisms extruded by 2d triangles generated by a delaunay mesher. I am struggling with the mesh file format in use by OpenFoam. I am using a very simple model to understand the proper content of the files: a cube composed two prisms connected by the common face. Running the checkMesh utility i have several errors. Particularly two cells are detected one prism and one tet wedge. Furthermore the model is seen as open. But i do not understand where the error can be. Attached you can find the OpenFoam files (points, faces, owner, neighbour,boundary) and the report generated by checkMesh utility. Thank you in advance for any help you can give me neri alamanni Last edited by neri.alamanni; August 27, 2010 at 03:43. |
|
|
|
|
|
April 14, 2014, 09:55
|
Same error
|
#2 |
|
New Member
Richel Bilderbeek
Join Date: Nov 2013
Posts: 14
Rep Power: 12 |
I have the same error. Documentation and solution will be at https://github.com/richelbilderbeek/...eek/issues/179
after I fixed the error.
__________________
I will never accept a 'Friend' request, I will always accept beer |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| Mesh Generation - Prism Layer Stretching | Tasneem | STAR-CCM+ | 3 | June 1, 2017 18:41 |
| [ICEM] Bad Quality | **Anny** | ANSYS Meshing & Geometry | 7 | May 28, 2015 05:03 |
| Prism mesh | Mohankumarg12 | ANSYS Meshing & Geometry | 7 | July 27, 2011 16:10 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Linear Mode
